
Nightforce 34mm Ring Cap Bubble Level A270 is made for scopes mounted in 34mm rings. It replaces the top half of the ring and puts a bubble level right into it. The scope stays where it was. You just gain a way to check the rifle before the shot.
A tilted rifle sends shots off to one side. The farther the target, the bigger that miss gets. Shooting off a barricade or from sloped ground makes cant easy to miss. With the level built into the ring, you can spot the tilt before you press the trigger. Nothing clamps onto the scope tube, so the setup stays clean. This Nightforce bubble level does one job and does it from a fixed spot.
The A270 uses a 4-screw top half. It takes the place of the top ring on Nightforce Unimount, Direct Mount, and standard rings that don’t have a Mil-Std 1913 base. There’s no ADI mount on this version. Rings in other sizes or with six screws need a different part, so confirm 34mm and a 4-screw top before you swap.
Installation is a few simple steps. Remove the existing top half. Line the level up with the mounting points. Tighten the screws until it’s firmly seated. The finish is black anodized aluminum. Check the bubble when you settle in, and again if you shift position. As far as scope accessories go, this is a small part with a clear purpose.
The A270 pairs the 34mm ring half with the level, so one piece does both jobs.
A270-NF
847362006956
A270
Nightforce
Add all 0 items in this product bundle to your cart with one click.

Earn 240 reward points (worth $2.40) when you purchase with the EuroOptic Rewards Credit Card.