Vortex Hunter 1-Inch Low (.63 Inches) Rings RING-L

Sometimes the best scope mounting solution is also the simplest one. The Vortex Hunter 1-Inch Low Rings give you a clean, reliable pair of rings that mount your 1-inch scope tube as close to the bore as possible for a natural, consistent shooting position. No unnecessary height, no complex installation — just solid rings that hold your optic where it belongs and keep it there through a full hunting season.

The RING-L sits at a center height of just 0.63 inches, making these some of the lowest profile 1-inch rings available for Picatinny and Weaver rail systems. For hunters running rifles where the objective lens clears the barrel comfortably at this height, low rings are almost always the right choice. They keep the scope close to the bore for better alignment, a more natural cheek weld, and a consistent shooting position that does not require you to crane your neck to find the sight picture. The 1 inch scope rings are low profile and also keep the overall rifle silhouette slim and easy to carry through dense country.

The Vortex 1 inch scope rings are machined from rugged 6061-T6 aircraft-grade aluminum that provides solid strength and reliable zero retention through regular hunting use. At approximately 1.55 ounces per ring, the hunter rings add minimal weight to your rifle build without compromising the structural integrity needed to keep your optic locked in place. The matte finish keeps glare off your setup in the field.

The Vortex scope rings install straightforwardly on both Picatinny and Weaver rails. Torque base clamp screws to 25 to 30 in-lbs and ring screws to 15 in-lbs for a secure mount that holds zero reliably. Note that these rings are not recommended for use on heavy-recoil rifles.

Find the Vortex Hunter 1-Inch Low Rings right here at EuroOptic and keep your hunting scope right where it belongs.