|
|
Michael Lewis
January 6, 2019
Standard Pelican quality, no questions asked. Of note, I have my cheek rest all the way up on my SRS. Had to cut more foam to get it to fit. Had to trim about 1/4” at the front of the hand guard to get that to fit. I run a Tangent Theta and the left knob for parallax sticks up quite a bit. Maybe a 1/4” of compressed foam between it and the hard case when closed. Wish it was about another 1/8” deeper. Last, lovely it has too many spots for magazines yet no predrilled spot for your seekins torque wrench or a place to put your extra long action bolt! There are two places for extra barrels, one 26” and one short 22”. If you have a 26” in the gun, you must remove your suppressor as it won’t fit. 3-stars for good effort, but the designer clearly missed the target on knowing what is standard additional carry items with a SRS switch barrel.
Eurooptic - happy to advise on 2-3 tweaks that would really make this product in the foam cut. Because let’s be honest, for $400 the extra cost is for an awesome pre-cut foam job as a standard Pelican case can be had for $150 less!
|
Bryan
October 25, 2017
The pictures do not do this case justice as the high density foam cut outs are not shown. The rifle area can fit with a large optic such as an S&B 5-25 but without a bipod unless you run an Atlas and fold the legs back. To that end there is an area that you can detach the bipod and store it since I run an EvoPod. 2 bolt cut outs, 2 barrel cut outs 26" and 22", several 6 round mag cut outs.
|
Scott
March 26, 2017
Awesome case and Eurooptic did a top notch job shipping out.
|